Module 3C Design Development and Testing post-learning

File:1623404860 HDX Post Learning 3C.jpg

Complete the following task :

1. Go look at the simulation: https://sigmazone.com/catapult/
2. Choose three design parameters and corresponding levels. Suggestions:
A: Release angle (Low=150, High=185)
B: Firing angle (Low=100, High=120)
C: Cup elevation (Low=250, High=300)
3. Run the 2^3 full factorial design which will require 8 runs of the simulation. Record the launch distances.

4. Estimate the main effect of release angle on launch distance.

LMS HOME